Printing

You have questions, we have answers. Here's how you can print beautiful brackets in your office.

• HOW DO I GET STARTED WITH MY SPRINTRAY PRINTER?
• HOW LONG DO I WASH BRACES ON DEMAND PARTS?
• WHAT IS THE RECOMMENDED TEMPERATURE TO CURE BRACES ON DEMAND PARTS?
• HOW LONG DO I CURE BRACES ON DEMAND PARTS?
• HOW LONG DOES IT TAKE TO PRINT MY OWN BRACKETS?
• HOW DO I REVERT FIRMWARE FOR MY FORMLABS 3B PRINTER?
• HOW TO PRINT WITH A FORMLABS FORM 3B PRINTER?
• WHAT EQUIPMENT DO I NEED TO PRINT MY OWN BRACES?
• HOW DO I STRAIN RESIN?
• HOW DO I KNOW WHEN I NEED TO CHANGE THE DIRTY ISOPROPYL ALCOHOL?
• WHAT IS THE BEST WAY TO REMOVE PARTS FROM THE BUILD PLATE?
• CAN YOU WALK ME THROUGH POST-PROCESSING?
• WHAT IF I HAVE A FAILED PRINT?
• HOW DO I WASH THE GLYCERIN OFF OF THE PARTS?
• CAN BRACKETS BE LEFT IN THE GLYCERIN FOR TOO LONG?
• CAN THE BRACKETS BE OVER-CURED? WHAT IF SOMEONE GOT THE TEMPERATURE CORRECT BUT DID THE DEFAULT 1 HOUR INSTEAD OF 30 MINUTES?
• WHY DO I NEED TO SUBMERGE BRACES ON DEMAND PARTS IN GLYCERIN?
• WHAT HAPPENS IF I ONLY CURE FOR 5 MINUTES?
• CAN I START A CURE IN GLYCERIN AND REMOVE THE BRACKETS THE NEXT MORNING?
• SHOULD I RINSE THE PARTS WITH IPA BEFORE PUTTING THEM INTO THE FORM WASH?
• DO I HAVE TO USE 99% ISOPROPYL ALCOHOL?
• CAN I USE THE SAME IPA AS MY MODEL PRINTS?
• DO I PROCESS MY PRINTS THE SAME AS MY ALIGNER MODEL PRINTS?
• WHEN WOULD I NEED TO STRAIN MY RESIN?
• CAN I START A PRINT AT THE END OF THE DAY BEFORE I LEAVE FOR THE WEEKEND?
• CAN I START A PRINT AT THE END OF THE DAY AND POST-PROCESS IN THE MORNING?
• DO I NEED TO CONFIGURE BRACES ON DEMAND PARTS ON PREFORM?
• WHY IS THERE A “CART” AND “PRINT” ICON?